Engine out wiring

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
hazynut
Settled in member
Reactions:
Posts: 5
Joined: Sat Feb 28, 2015 4:24 pm
Location: Uttoxeter, Staffordshire, UK
Engine out wiring

Post by hazynut » Sun Jan 05, 2020 4:12 am

Hi all doing an engine swap in my gk76 gsxr400 got to the point of engine loose in the frame, my question is I can't see any plugs to remove engine part of the wiring loom such as ignition coil pick ups and alternator seems to be a number of wires for these under the starter motor with no obvious way of undoing them from the loom, it's a bit dark in the shed I am working in and is hard to trace anything back. Any help would be much appreciated thanks re Alistair

mechannibalism
Settled in member
Reactions:
Posts: 32
Joined: Fri Sep 21, 2018 10:12 pm
Re: Engine out wiring

Post by mechannibalism » Sun Jan 05, 2020 7:02 pm

This seems to be a Suzuki thing, you have to follow them up into the harness but they do disconnect. I went thru the same thing recently with a Kantana I parted out.

moforockband
Familiar Member
Reactions:
Posts: 353
Joined: Wed Jun 03, 2015 9:41 am
Bike owned: GK73a SP CRM250 mk3
Re: Engine out wiring

Post by moforockband » Mon Jan 06, 2020 10:50 am

Complete wiring loom stays in the frame, once disconnected drop the motor. :) No need to remove any part of the loom usually..

hazynut
Settled in member
Reactions:
Posts: 5
Joined: Sat Feb 28, 2015 4:24 pm
Location: Uttoxeter, Staffordshire, UK
Re: Engine out wiring

Post by hazynut » Mon Jan 06, 2020 9:19 pm

Thanks all for the advice


Post Reply