Ive been offered a front end from a ZXR. Forks, Yokes, Steam, Calipers, etc etc.

I'm wanting to put them on my NC29, Im guessing the forks will fit into a set of RVF yokes (50mm) which fit straight onto the NC29 with little mods.
My problem lies with the wheel/disks.

Does the ZXR have a 20mm front axle like the NC29?
Im guessing I will need to keep the ZXR calipers, Not only are they 4 pot (NC29 are twin pot sliders), They are made for the forks.
But Im wanting an NC29 front wheel.

So the problem is then going to be with the Disks. I suppose NC29 disks will be needed to fit the NC29 wheel, But the calipers arent going to line up with the disks are they?
And even if they did, I cant see the ZXR pads being great for the NC29 disks.

Anyhoo, I'll cross that bridge when I come to It, I need to know if an NC29 wheel will go onto a ZXR axle (20mm).


Ben