hi guys is this possible to do. has any one tried with success or failure?
any advice or ideas gladly received
thanks
yamaha fzr400 NC24 single swingarm conversion??
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
fzlintstone
- Settled in member
- Posts: 5
- Joined: Sun Dec 27, 2015 9:06 pm
- Bike owned: rgv250, gsxr400 fzr400 fzr600
-
jim157
- Admin NWAA
- Posts: 1004
- Joined: Mon May 17, 2010 7:15 pm
- Bike owned: A few small ones
- Location: Norwich
Re: yamaha fzr400 NC24 single swingarm conversion??
I don't see the point personally. It's not as if the nc24 rear end gives you any advantages: it will be heavier and has a skinny rear tyre.
AUTOEXEC.TWAT
-
hunter
- Site Supporter
- Posts: 1292
- Joined: Thu Nov 20, 2008 1:09 pm
Re: yamaha fzr400 NC24 single swingarm conversion??
What model fzr,
I've put a 30 arm on a 3TJ.
I've put a 30 arm on a 3TJ.
-
Wraith
- Settled in member
- Posts: 106
- Joined: Tue May 20, 2008 9:11 am
- Location: Washington. Tyne & Wear.
Re: yamaha fzr400 NC24 single swingarm conversion??
I will let you know as I have all the bits
I'm doing it purely for cosmetic reasons
Plus I managed to pick up the Complete Rear (With nearly new tyre) for only £27 Delivered
Fitting it to a 3en1
Haven't done any measuring yet though (Hope not too much work)
New Swing Arm Pivot Bolts will need to be Machined
Originals
Original Center Mount
I'm doing it purely for cosmetic reasons
Plus I managed to pick up the Complete Rear (With nearly new tyre) for only £27 Delivered
Fitting it to a 3en1
Haven't done any measuring yet though (Hope not too much work)
New Swing Arm Pivot Bolts will need to be Machined
Originals
Original Center Mount