Hi all,

Are all versions of the 3TJ ('89-'94) using the same front calipers. I am looking to source some braided lines for a new project, but can only see Hels listing for a FZR400RR 94-96.

Many thanks

Aidan

Yes all the 3TJ and 4DX's are same.

Chances are your going for the two lines from the brake master cylinder and all the brake manufacturers can do those but you'll need to measure and provide them with the length. Hel lines are as good anybody's and I think (but check it) they have swivel couplings which make fitting a lot easier

Thanks for that Matey.

I had done a little search on here but couldn't find anything. I'll get in touch the the Hel man in the morning.

I've got some Goodridge ones on fleabay at the minute. They were taken off an NC30/Brembo set up but I've had them on my TRX. They're 550mm and 600mm long, with black coating over the stainless braid. They'll fit the 3TJ.

thanks for the offer mate, but i've already ordered some.

regards

Aidan

al_hrc wrote:thanks for the offer mate

No probs! x