3TJ Exhaust link pipe problem (with pic)

crashtestdummy · Post by **crashtestdummy** » Mon Jun 02, 2008 5:29 pm

I got my link pipe from the Carbon Can Co as well. The can is the same brand, its a titanium oval beauty from ebay for Â£80 :D

I'm going to give it another go later this evening, poss with a hammer if it pi55es me off. Will post some pics

oldgreg · Post by **oldgreg** » Mon Jun 02, 2008 5:51 pm

My pipe is flared both ends (oh err missus

)

dunno if its the same bit of kit, but here is a pic.....

Please excuse the rusty bits - i keep meaning to grab some stainless bolt but never get round to it

crashtestdummy · Post by **crashtestdummy** » Wed Jun 04, 2008 11:10 pm

ooolit could you do me a favour and take a pic of just the link pipe as i supposedly have the same one as you (carbon can co) My link pipe has two shallow bends which cant be right. Cheers

Post by **Evilchicken0** » Wed Jun 04, 2008 11:30 pm

Hey old greg - if you turn the exhaust clamps around the bolt head will be on the outside and it will look better.

Post by **oollit** » Wed Jun 04, 2008 11:56 pm

I will try to get a photo of the link pipe posted tomorrow.

My screen on my phone is knackered and that is the only digital camera i have, but i will try and rob my brothers one.

crashtestdummy · Post by **crashtestdummy** » Thu Jun 05, 2008 11:16 pm

As you can see its got two shallow bends which doesnt seem right. Oldgreg's is what it should be like. Have i been sold a duffer?

Post by **Motorcycle Solutions** » Fri Jun 06, 2008 1:08 am

yes there should only be one shallow bend at the bottom by the clamp... for the 3tj model.

crashtestdummy · Post by **crashtestdummy** » Fri Jun 06, 2008 1:46 am

ahhh... will send it back then :D

Cheers

Post by **Evilchicken0** » Fri Jun 06, 2008 5:50 pm

That looks like a 1WG link pipe to me

Q007 · Post by **Q007** » Sat Jun 14, 2008 12:38 am

where the bracket attaches to the rear hanger get a longer bolt and fit spacers, my ART can was fouling the swingarm till i did this now it's about 10-15mm clear of the swing arm..Difficult to fit unless you've got 3 arms but once it's done it looks awesome..

Q

3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)

Re: 3TJ Exhaust link pipe problem (with pic)