3TJ Timing with no rotor

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Site Supporter
Site Supporter
Posts: 750
Joined: Tue Apr 29, 2008 9:37 pm
Bike owned: NC29 CBR600F
Location: Lancashire
Re: 3TJ Timing with no rotor

Post by cbr400rrn » Wed Feb 07, 2024 11:51 pm

Ant142 wrote:
Sun Feb 04, 2024 10:04 am
KIYOSHI wrote:
Fri Jan 03, 2014 9:22 pm
If the ports are untouched i can't see it doing much more than stock. I'll PM you a very good setup when I get a moment. It will require the cams dialing in and a bit if stripping/rebuilding but will give you a very strong motor with power output below 140000rpm.

You should also pre-load the valve springs by installing washers below the spring seat, keep the valve from jumping into bed with the pistons :-)
I know this is an old post but I’d be very interested in any set up advise you can send me, especially regarding cam timing. I’m a bit late to the party it just getting into racing an fzr.
Sorry but kiyoshi hasn’t been on here since 2016, hopefully someone else will help though

Post Reply