Fairing infill fittings 3TJ
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
- Settled in member
- Reactions:
- Posts: 22
- Joined: Fri May 01, 2015 8:28 am
- Bike owned: RSV-R,RD350,MV F4,FZR,ST2,GSXR
- Location: Warrington
Fairing infill fittings 3TJ
Does anyone know where I can get some fixings for my infill panels? both of my bikes have screws missing.
-
- Site Supporter
- Reactions:
- Posts: 5374
- Joined: Tue Apr 29, 2008 8:59 pm
- Bike owned: Bimota SB6 Yamaha FZR 3TJ x2
- Location: Lundin Taan
Re: Fairing infill fittings 3TJ
They use well nuts, they're brass threaded bits set in rubber or plastic. You can get them in Halfords in a pack of 5 or 6 I think, they're used for screens ... possibly M5
-
- Settled in member
- Reactions:
- Posts: 212
- Joined: Wed Jul 23, 2008 3:33 pm
- Location: Rainham, Kent.
Re: Fairing infill fittings 3TJ
Unless it is the screws that go into the top fairing, these just screw into the plastic.
Alex.
Alex.
-
- Settled in member
- Reactions:
- Posts: 22
- Joined: Fri May 01, 2015 8:28 am
- Bike owned: RSV-R,RD350,MV F4,FZR,ST2,GSXR
- Location: Warrington
Re: Fairing infill fittings 3TJ
Thanks guys I will go and grab some well nuts, do you know what size the self tappers are that go into the front faring?
-
- Site Supporter
- Reactions:
- Posts: 5374
- Joined: Tue Apr 29, 2008 8:59 pm
- Bike owned: Bimota SB6 Yamaha FZR 3TJ x2
- Location: Lundin Taan
Re: Fairing infill fittings 3TJ
Don't know the size .... but here's a top tip
Cut the end of the self tapper off, take 3-4mm and make it flat. This is so the sharp end doesn't push through to the front fairing
Cut the end of the self tapper off, take 3-4mm and make it flat. This is so the sharp end doesn't push through to the front fairing
-
- Settled in member
- Reactions:
- Posts: 22
- Joined: Fri May 01, 2015 8:28 am
- Bike owned: RSV-R,RD350,MV F4,FZR,ST2,GSXR
- Location: Warrington
Re: Fairing infill fittings 3TJ
I have a dislike for Wellnuts, I had an MV Agusta and the factory had decided to use them to hold some covers onto the airbox. unfortunately heat and fuel turns most rubber into slop and the brass inserts almost fell into one of the throttle bodies!
-
- Site Supporter
- Reactions:
- Posts: 5374
- Joined: Tue Apr 29, 2008 8:59 pm
- Bike owned: Bimota SB6 Yamaha FZR 3TJ x2
- Location: Lundin Taan
Re: Fairing infill fittings 3TJ
They're nowhere where they can fall into anything or get contaminated