Fzr400 Non runner

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
sam5473
Settled in member
Posts: 14
Joined: Sun Nov 01, 2009 9:09 pm

Fzr400 Non runner

Post by sam5473 » Mon Dec 28, 2009 9:32 pm

Hi I recently bought an fzr400 that already had the fuel tank cover, fairing, exhaust off, I also took the airbox off. I went to start it and the bike turnsover but won't start. I found that I had no fuel flow, and found out it was a blocked fuel filter so thats been replaced. I have checked that there is fuel flow into the carbs and thats fine now. The spark plugs are new and the spark's good. I have tried putting fuel straight in the top of the carbs and it makes more of an effort of starting but still doesn't. Is there something I should check next?

barryfzr
Site Supporter
Site Supporter
Posts: 144
Joined: Wed Apr 30, 2008 11:12 pm

Re: Fzr400 Non runner

Post by barryfzr » Mon Dec 28, 2009 11:26 pm

ht leads the right way round? are the plugs getting wet?

sam5473
Settled in member
Posts: 14
Joined: Sun Nov 01, 2009 9:09 pm

Re: Fzr400 Non runner

Post by sam5473 » Tue Dec 29, 2009 11:16 am

the ht leads are going 1,2,3,4 from the left
and the spark plugs smell of petrol when you take them out

hunter
Site Supporter
Site Supporter
Posts: 1292
Joined: Thu Nov 20, 2008 1:09 pm

Re: Fzr400 Non runner

Post by hunter » Tue Dec 29, 2009 1:44 pm

How fast does the engine turn over,does it seem to spin fast, does it feel it has compression.

Evilchicken0
Site Supporter
Site Supporter
Posts: 5374
Joined: Tue Apr 29, 2008 8:59 pm
Bike owned: Bimota SB6 Yamaha FZR 3TJ x2
Location: Lundin Taan

Re: Fzr400 Non runner

Post by Evilchicken0 » Tue Dec 29, 2009 8:34 pm

A compression test would be the best thing to esablish if the engine is ok.

But lets say you have a good compression.

you'll need the air box off, the fuel tank on (and the carbs cleaned). Put a pair of jump leads or a strt pack on the battery (The car doesn't have to be running). Put a good squirt of carb cleaner down the carbs, lift the slides and put it under them. choke off.
Hold the starter button on and gently open the throttle a bit and keep the carb cleaner sparyed over the open carb intakes. After a while you'll hear the engingine turn over quicker and quiker before it starts to catch ... keep the starter and carb cleaner going and the eginge will catch more .... eventually the enginge should run on it's own on the throttle ... open the choke and see if will go on that.

It's not a nice thing to do to an engine.

If it flatly refuses to start then you'll probably fing the valve clearances have closed to zero

Post Reply