Page 1 of 1

Ethos Design v Tyga exhausts

Posted: Thu Oct 31, 2019 8:48 pm
by BaldricksTurnip
Hey all.

My 1991 NC30 has an Ethos Design full system on it, which is a major headache for bodywork fitting (apparently pushes the lower rad out, and interferes below the engine). Thinking of switching out to a Tyga system, since I'm fitting Tyga bodywork. Anyone have any experience with fitting an Ethos end can onto a Tyga system, or am I best to just go ahead and order an end can, too?

Many thanks for any info.

Re: Ethos Design v Tyga exhausts

Posted: Thu Oct 31, 2019 10:21 pm
by Vincent
Get your calipers out, measure the ID of the Ethos can, and ask Tyga whether it'll slot onto their system. If the diameters line up it should be fine, but IIRC the Tyga system is a bit wider than the Ethos.