Ethos Design v Tyga exhausts

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
BaldricksTurnip
Settled in member
Reactions:
Posts: 9
Joined: Thu Aug 30, 2018 6:46 pm
Bike owned: 1991 VFR400R NC30 (track)
Ethos Design v Tyga exhausts

Post by BaldricksTurnip » Thu Oct 31, 2019 8:48 pm

Hey all.

My 1991 NC30 has an Ethos Design full system on it, which is a major headache for bodywork fitting (apparently pushes the lower rad out, and interferes below the engine). Thinking of switching out to a Tyga system, since I'm fitting Tyga bodywork. Anyone have any experience with fitting an Ethos end can onto a Tyga system, or am I best to just go ahead and order an end can, too?

Many thanks for any info.

Vincent
Settled in member
Reactions:
Posts: 65
Joined: Sun Jul 06, 2014 12:49 am
Bike owned: '89 NC30 T1, '92 NC30 T8
Location: New Zealand
Re: Ethos Design v Tyga exhausts

Post by Vincent » Thu Oct 31, 2019 10:21 pm

Get your calipers out, measure the ID of the Ethos can, and ask Tyga whether it'll slot onto their system. If the diameters line up it should be fine, but IIRC the Tyga system is a bit wider than the Ethos.


Post Reply