Rearset NC35

andreasmkr · Post by **andreasmkr** » Fri Mar 25, 2016 11:58 am

Does anyone know or have had the experience with fitting a Honda CBR rear set or another model to the NC35?

My aftermarket rear sets are getting worn and I want to replace them with something like these:

http://www.ebay.com/itm/REARSET-REAR-SE ... SwYlJW4VWL

I know the gear mechanism is a bit different but that can be modded. Would distance between bolts on the CBR match the NC35 frame mounts?

Post by **Cru Jones** » Fri Mar 25, 2016 8:41 pm

andreasmkr wrote:I know the gear mechanism is a bit different but that can be modded. Would distance between bolts on the CBR match the NC35 frame mounts?

Doubtful. You would have to measure to be sure. It would be a lot of effort to get some rearsets made for another bike to work on the 35. Just pony up and get a set of new nice rearsets made for the 35.

Post by **jim157** » Fri Mar 25, 2016 10:01 pm

I'd be inclined to buy some quality SES ones over the ones from China. The advantage being SES sell all the separate components as spares should you need to repair or rebuild them in the future.

andreasmkr · Post by **andreasmkr** » Sat Mar 26, 2016 10:49 am

That's a good point jim157.

newtothis · Post by **newtothis** » Sat Mar 26, 2016 10:11 pm

Yamaha YZF r125 ones have the same bolt spacing (I know - wash my mouth out!) as the chassis stands I made for that fit perfectly. It's possible therefore that other Yamaha's might just use the same spacing, whcih might provide some options.

Rearset NC35

Rearset NC35

Re: Rearset NC35

Re: Rearset NC35

Re: Rearset NC35

Re: Rearset NC35