Hi all, so I got my fork sliders back today after them being powder coated, I got them home and checked them over, I noticed that some of the powder had got inside the slider tube, only dust particles but they have been heated so won't just wipe away, will this effect the forks? A stanchion with bush goes in and is not tight but I worry the bush with ware faster?

Thanks in advance

Try a bit of gasket remover, that'll get rid of your excess powdercoat. I used it to good effect when some parts of my frame were coated where it wouldn't have been. (Engine mounting points and some points where smaller bolts screw in)