RE: Clearance issues with fork tops raised above yoke

Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Post Reply
marty400
Familiar Member
Posts: 250
Joined: Thu Jun 19, 2008 2:06 pm

RE: Clearance issues with fork tops raised above yoke

Post by marty400 » Thu Jan 22, 2015 9:29 pm

Hiya All,

RE: Clearance issues with fork tops raised above yoke

hhmmmm... thinking about CBR600f Uppers on a NC29.
However, longer than the 400 fork tubes, so will need to stick out a bit over the yoke....

How high can the fork tops go above the yokes, before clearance issues with the Screen brace at full lock etc?

I measured 30mm clearance at full lock.... it that to tight?

hope you can advise

Regards
Martin
Top
marty400
Familiar Member
Posts: 250
Joined: Thu Jun 19, 2008 2:06 pm

Re: RE: Clearance issues with fork tops raised above yoke

Post by marty400 » Fri Jan 23, 2015 7:56 am

Can the cbr600 fork tubes be cut down, and everything still fit internally?

What are the internal unit lengths though like, compared to std dampening rods etc.
Cheers
Martin

Ps: Fork tube lengths found:
Nc29 fork tubes are approx 6cm shorter!
(What about the the fork lowers as well?!)

Cbr6:
Fork Tube Honda CBR 600 F3 95-98, 1 piece, Diameter 41mm, Length 633mm, OEM Part Number 51410MAL601


Nc29:
BRAND NEW "ABE" FORK STANCHION FOR HONDA CBR400RR GUL ARM.
NC29.1990-1994.LENGTH- 572mm,DIAMETER-41mm.


Nc30:
533mm from forum post
Top
Post Reply

Return to “Honda - Workshop”