Nc24 cuts out on stand

gissmo50 · Post by **gissmo50** » Tue May 20, 2014 9:28 am

Right I've got an odd one started getting the nc24 ready for it's mot first in a year or so. I took her out and when hot she would die at idle, checked the mixture screws and the where a 2 turns out so I reset them at 2.5 as recommended. She seems to run better and has lost a big flat spot in the middle but if you put her on the side stand when she's hot she dies standing up she's fine idles smooth and constant. Anybody got any ideas?

Cheers Gissmo

gissmo50 · Post by **gissmo50** » Wed May 21, 2014 5:26 pm

More to this now went to take her out for an mot thought riding her might help clear her out but alas I now have a massive misfire and she will not pull about 4-5k I suspect an air leak or carbs full of shit.....

Post by **Neosophist** » Thu May 22, 2014 2:59 pm

have you chcked the vaccum pipe?

gissmo50 · Post by **gissmo50** » Thu May 22, 2014 4:41 pm

I haven't tbh she got put away last night and left but the tap has been modded so the vacuum isn't needed was giving me grief when it was a vacuum tap

Nc24 cuts out on stand

Nc24 cuts out on stand

Re: Nc24 cuts out on stand

Re: Nc24 cuts out on stand

Re: Nc24 cuts out on stand