The left brake light went out on the RVF400 and I found a modified replacement LED from Japan. This is the one with the square LED pattern with a row of LED's for the license plate light. This one also has a single 3 wire cord with a ROUND connector, not the square 4 pin female connector.
Any thoughts on how to re-wire with the correct connector? Should I just get an OEM replacement?
NC35 Rear brake light replacement LED from Japan
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Rrotz
- Settled in member
- Posts: 78
- Joined: Wed Nov 28, 2012 11:23 pm
- Bike owned: 96 MC22, 89 NC30, 96 NC35
- Location: VIC, Australia
-
Cammo
- Site Supporter
- Posts: 4505
- Joined: Thu May 01, 2008 12:35 am
- Bike owned: NC30
- Location: Melbourne, Australia
Re: NC35 Rear brake light replacement LED from Japan
Those Japanese led lights do look good, but not cheap once they've landed at your door.
Not so elegant, but I use cheap led globes off ebay and they work fine, similar to this: http://www.ebay.com.au/itm/12V-36-LED-B ... fdf&_uhb=1
Not so elegant, but I use cheap led globes off ebay and they work fine, similar to this: http://www.ebay.com.au/itm/12V-36-LED-B ... fdf&_uhb=1
"It's just a ride" Bill Hicks