I posted here a while ago that my tacho was running at half speed. A few people suggested (based on the pics) that it was a RVF tacho. I've since ordered one from the wreckers and it arrived on Friday.
Problem is the wires dont add up. Each seem to have a black/green combo which is the earth/ground.
But the RVF tacho just had one yellow with green stripe wire connected from the back to the bike. The NEW tacho has a connection with a yellow/green stripe wire and a brown wire coming from it. I have cut the connection and tried to wire them independantly to the bike's lone yellow/green stripe wire to no avail.
Ive done some searching on google but again no luck. Can anyone help pls?
Wiring for tacho on NC30
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Keenaz
- Settled in member
- Posts: 10
- Joined: Mon Apr 08, 2013 3:35 am
- Bike owned: VFR400
- Location: QLD, Australia
-
magg
- Senior Member
- Posts: 1914
- Joined: Mon Sep 20, 2010 11:55 pm
- Bike owned: VFR400
- Location: Blue Mountain NSW Australia
Re: Wiring for tacho on NC30
NC30 tacho connections are:
Green - earth
Yellow/green - ignition signal
Black/brown - 12V power.
Green - earth
Yellow/green - ignition signal
Black/brown - 12V power.
-
Keenaz
- Settled in member
- Posts: 10
- Joined: Mon Apr 08, 2013 3:35 am
- Bike owned: VFR400
- Location: QLD, Australia
Re: Wiring for tacho on NC30
Cheers Magg, I sent you a PM :)