clutch install question!
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
ZXESAS
- Settled in member
- Posts: 28
- Joined: Fri May 10, 2013 6:05 pm
clutch install question!
Hi guy's i got my new clutch kit and i was wondering is it ok to use my old oil that i drained from my bike to soak the clutches in? i will be putting fresh oil in it but i want to just install them so when my engine covers come back from painting everything is ready to just bolt on and pour fresh oil? So is it ok or should i wait until i get fresh oil? And also 10-40 synth is it ok for my bike?
-
leopard_pagan
- Senior Member
- Posts: 1184
- Joined: Thu May 01, 2008 6:42 am
- Bike owned: CBR400/600 Fighter
- Location: Mildenhall-Suffolk
- Contact:
Re: clutch install question!
didnt think you still needed to pre-soak modern friction plates..
but if you did.. i dont see why soaking in old oil is any problem.
i use 10/40 semi bike oil for my NC29.
but if you did.. i dont see why soaking in old oil is any problem.
i use 10/40 semi bike oil for my NC29.
-
ZXESAS
- Settled in member
- Posts: 28
- Joined: Fri May 10, 2013 6:05 pm
Re: clutch install question!
Thank's Leopardleopard_pagan wrote:didnt think you still needed to pre-soak modern friction plates..
but if you did.. i dont see why soaking in old oil is any problem.
i use 10/40 semi bike oil for my NC29.