Hi guys,
With the throttle cam on the carb bank wide open, does the rear sync screw "normally" touch the bracket that runs down the center of the carb bank? I compared the unit on the bike with a spare set I have and both touch at about the same spot which is about 1/8 inch from the throttle cam stop...I'm wondering if anyone else has noticed this?
Thanks!
RVF carb question
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Tornado
- Settled in member
- Posts: 65
- Joined: Tue Jul 12, 2011 4:20 am
- Location: Alamosa, CO.
-
Neosophist
- Moderators
- Posts: 8172
- Joined: Fri Jul 04, 2008 1:01 pm
- Bike owned: CBR954
Re: RVF carb question
Maybe they've been screwed in too much.
I can't check yet but if it isn't normal then screw them all the way out and start again if you have a carb balancer.
I can't check yet but if it isn't normal then screw them all the way out and start again if you have a carb balancer.
xivlia wrote:i dont go fast on this bike so really do not need a rear brake.. /
vic-vtrvfr wrote:Ask xivlia for help, he's tackled just about every problem u could think of...
-
Tornado
- Settled in member
- Posts: 65
- Joined: Tue Jul 12, 2011 4:20 am
- Location: Alamosa, CO.
Re: RVF carb question
The adjustment screw hits the bracket whether the screw is all the way in or all the way out on both sets of carbs. Any other ideas? Thanks.