Starting problems

Post by **vic-vtrvfr** » Sat Dec 29, 2012 9:00 pm

Hi folks
Hope you're all having a merry crimbo.
I know this topic has prob been covered before but need wisdom.
tried to start project #2 today, been neglecting the NC's due to workload.
It ran ages ago but been standing since.
It had a service including new plugs at the time.
But now the bugger won't start. I checked plugs, all getting spark.
Took all 4 out, cleaned them & tried again with no luck.
Checked plugs again, rear 2 totally dry, front 2 wet & quite dark.
Battery was fully charged too

Any advice? Pull carbs off for a clean etc?
Thanks
Vic

Post by **thunderace** » Sat Dec 29, 2012 10:29 pm

Carb fettling time

Post by **CMSMJ1** » Sun Dec 30, 2012 10:23 am

new plugs time too...or bake them good and proper.

put the wet ones in the back as they might not get drowned so easy..

Post by **vic-vtrvfr** » Sun Dec 30, 2012 10:27 am

Thanks guys
Hoping to get more tinker time today so will see how things go.

hannakournikova · Post by **hannakournikova** » Sun Dec 30, 2012 12:05 pm

Carbs seated properly Vic?

Post by **vic-vtrvfr** » Sun Dec 30, 2012 12:51 pm

Not certain Chris, though pretty sure.
I'm starting again shortly, will check it out