I've fitted braded lines recently but as they have a smaller diameter than the stock lines, the standard hose guide is no good.

So, how are you all tying your braided lines out of the way?

I've got a zip tie on there at the moment but it is a little unsightly and i'm worried about it rubbing through the lines.

I normally replace the OE bracket with rubber lined P clips, stainless ones. Cheap enough and they have an M6 mounting hole. Perfect

Pliers.....pinch the original holder.....

Cable tie

porndoguk wrote:Cable tie

Yep thats what I used for the front and used the original rubber grommet type things for the rear, just squeezed the clips a bit to secure them, didn't look that great but works. You can, I believe, drill holes in the swing arm front and rear and thread the hose through. Personally I couldn't be arsed with that but I'm sure it looks better