NC30 NC35 Front spindle

[Lane]

G'day lads,

Putting an NC35 back together and found that the front spindle is about 10-15mm too short, i didn't realise when i was stripping it many months ago.

I suspect it has a VFR front spindle?

I did a bit of searching and am fairly confident of the slight difference, can anyone confirm if this is the case?

And to think i did about 5km's on this bike before i stripped it, some people just shouldn't pick up spanners!!!

Thanks in advance.

[arsey30]

I have not taken them both out to measure, but by poking a tape measure up the hollow centres until it touches the end of the spindle bolt, I find the NC35 reads 230mm, NC30 215mm, so I think you are right.

[Lane]

Thanks Arsey, that's enough for me.