Hi guys I was wondering if there was any info on this I've done a search but not found a great deal.
How big are the holes you drill? Where exactly do you drill them? And does this weaken the Swingarm caused anyone any trouble with mot etc

Any help is much appreciated

think ricky(porndog) done this mod mate, try giving him a pm. sure he wouldnt mind.

Check out the link below, it'll give you a pretty good idea how to go about it...

viewtopic.php?f=24&t=23940&start=0&hilit=swingarm

and a few more photos from Akhara...

http://www.akhara.com/nc30/nc30rearbrakeline/index.html

Good luck

i drilled 2 x 20mm Dia, one in the centre just behind the shock,

the hole you drill near the hub end there is a (20mm ish dia) circular manufacturers mark from the cast mould, you need to drill central to this 10mm towards the front as if you drill directly on it youll screw up and drill into the hub/bearing holder.

Rick

RoninZX-10R wrote:Check out the link below, it'll give you a pretty good idea how to go about it...

viewtopic.php?f=24&t=23940&start=0&hilit=swingarm

and a few more photos from Akhara...

http://www.akhara.com/nc30/nc30rearbrakeline/index.html

Good luck

saved me having to search

Thanks for the help guys