Anyone had any luck removing these, mine have siezed and the crossheads snapped off

Yep that's me, got a set of rvf carbs one day, sat in the sunshine beside Claire to clean them and adjust them to stock and snapped all but one screw. £65 well spent.

Had to drill the screws and tap in a torx bit to remove then asked Aly Bayley ( I think it was ) for 4 new ones, I think Honda were expensive for them.

Good luck buddy

lol i got plenty of spares. Never thought of a torx bit, cheers pal

Left hand drill bits are good too.