Oil Change Question NC30

Post by **mattiec321** » Sun Dec 11, 2011 11:28 am

Hi there chaps n chapesses.

I've changed to oil on the bike today, but am wondering where to take the dipstick reading from.

Screwed in or dropped from the bottom thread of the dipper?

Answers please.

Thanks

Matt

Post by **Neosophist** » Sun Dec 11, 2011 11:40 am

Don't screw it in, just rest it.

Make sure bike is on level ground and upright.

Post by **racingt** » Sun Dec 11, 2011 8:48 pm

Well answered Neo, I've been doing it wrong for years.
Apparently it is also a daily check. Personally can't see the point unless you are planning to ride it......

Post by **Man_Named_Dave** » Sun Dec 11, 2011 8:53 pm

racingt wrote:Well answered Neo, I've been doing it wrong for years.
Apparently it is also a daily check. Personally can't see the point unless you are planning to ride it......

I'd call it an 'End of Day Check' as it's not supposed to be done from cold, but as the engine's warming down.

dgunthor · Post by **dgunthor** » Mon Dec 12, 2011 2:13 pm

I've always measured my oil (car/bike/etc) on level ground COLD - thought engine cold was the time to measure?

magg · Post by **magg** » Tue Dec 13, 2011 1:26 am

Common Service Manual from Honda says to check oil run engine at idle for a few minutes, stop engine and wait 2-3 minutes and then measure oil level without screwing the dip stick into the crankcase. Also says to follow any model specific owner's manual instructions.

Do not know of an English version of the owner's manual for NC30, so I run with the Common Service Manual.

Does anyone know of or have a copy of an English owner's manual.

Post by **CRM** » Tue Dec 13, 2011 7:51 am

magg wrote: Do not know of an English version of the owner's manual for NC30, so I run with the Common Service Manual.

Does anyone know of or have a copy of an English owner's manual.

do you mean the one on the homepage ? or the one that came with new UK spec bikes

magg · Post by **magg** » Tue Dec 13, 2011 8:57 am

CRM, are you referring to the service manual? If so, I have a copy but cannot find any reference to oil change procedure in the maintenance section. We here in oz have little or no documentary support for the 400 v4s which is why I have relied on the Honda Common Service Manual when I cannot find the answer in the service manual.

Post by **CRM** » Wed Dec 14, 2011 6:25 pm

Magg, i do have a UK spec bike and all the documentation that came with the bike and low and behold there is a section on checking the oil
see attached - sorry its massive - at least you wont have any trouble reading the print lol

DSCN1194.JPG

magg · Post by **magg** » Thu Dec 15, 2011 12:26 am

Thanks CRM, the advantage of a factory supported import. In oz Honda does not recognize these bikes, no help what so ever with spares or documentation.

Oil Change Question NC30

Oil Change Question NC30

Re: Oil Change Question NC30

Re: Oil Change Question NC30

Re: Oil Change Question NC30

Re: Oil Change Question NC30

Re: Oil Change Question NC30

Re: Oil Change Question NC30

Re: Oil Change Question NC30

Re: Oil Change Question NC30

Re: Oil Change Question NC30