Page 1 of 1

nc30 vfr400 handle bar removal

Posted: Thu Dec 01, 2011 5:32 pm
by leerc
do the forks need to come off to get it off? the wind blow my bike over on saturday and snapped the bolt holding the bar end on

Re: nc30 vfr400 handle bar removal

Posted: Thu Dec 01, 2011 6:26 pm
by spud
leerc wrote:do the forks need to come off to get it off? the wind blow my bike over on saturday and snapped the bolt holding the bar end on
hi ,

you just need to undo the big centre nut on the top yoke , then undo the two pinch bolts . think there 6mm allen key bolts , take them out and then gently give the top yoke a tap with a rubber hammer and should pull off . think thats the easiest way round it

spud