Page 1 of 1

air scoops to tank cover

Posted: Tue Jun 21, 2011 1:21 pm
by isca1987
Hi i have bought carbon air scoops and front tank cover but when i took the old ones off they were held on with wood screws, I'm guessing it should be a nut and bolt each side but does any one know where i can get the right nuts & bolts from?
Also on the old air scoops there was a bit of rubber going around the bottom does anyone know where i can get that from?
I would be really thankful if anyone does know as when i went into honda they said they don't sell bits like that.

Re: air scoops to tank cover

Posted: Tue Jun 21, 2011 1:32 pm
by BillingCBR
at a Honda dealer, tell them you want 2 of 64121MR8900, should be about a fiver each, that or go on DavidSilverSpares.co.uk an put that in the search by part number section.

The screws could be panel screws, which do look like wood screws, the proper ones are available from DSS, but are special order, 2 of 90101692000 will see you right :up:

EDIT: Both are special order, the total delivered including VAT is £15.08