nc35 torque settings
Posted: Mon Jun 20, 2011 8:17 pm
hi i am replacing my headrace bearings and need the torque settings for the steering stem lock nut and the head stock bolt ? thanks
NC30
The lock nut should be finger/hand tight with a new lock tab, but backed off a 1/4 turn with an old one, but the adjuster nut 36ft/lbs.
Top nut 101 ft/lbs,
top yoke 8
bottom yoke 28
clip on 9
NC35
As above but top nut 105nm
Adjuster nut 25nm
Top yoke 23nm
bottom yoke 40nm
Clip on 27nm
Dave.