Has anyone had any problems getting the pad pin covers unscrewed? mine seem stuck solid, I'm thinking of getting an impact screwdriver on the case. any other ideas?

thanks!

R

Yep, try your impact driver but I know had to chisel them around (carefully) with a flat head driver. I now have some with allen heads and made of titanium from probolt, that should save some weight then!

lol, gave it a go just now, screwdriver and rubber mallet rather than my lump hammer and drift. some good solid whacks and they cracked off. pins underneath were in perfect condition. all I have to do now is clean the pistons up and doa fluid change. Luverly!

Thanks again!

Rich