Hey all, just put in some new front wheel bearings, following the haynes instructions.
Put in left bearing first, it goes in about a mil deeper than the right, with the spacer stopping the right from going in any deeper.
When the seals go in, the right seal is flush and the left is inset about a mil... Is this normal? Im concerned the wheel is going to be offset to the left now.
Anyone done front wheel bearings?
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
MexicanGringo
- Familiar Member
- Posts: 315
- Joined: Sun May 25, 2008 10:41 am
- Bike owned: '30
- Location: Durban, RSA
-
Marcus127nc29
- Settled in member
- Posts: 80
- Joined: Tue Aug 04, 2009 8:06 pm
- Bike owned: nc29,mc19,er6,gpx250,kx125
- Location: evesham
Re: Anyone done front wheel bearings?
ive done mine a few times now as long as the spacer in the middle is not moving around and is a good fit between both bearing they should be fine put it back in and test for play jobs a goodun