zYgoat wrote:Hi all!

Just a quick one... was hoping you guys could help me out and tell me what these are for?

This is some kinda clip on the pillion seat strap... original purpose intended?

it isnt original as far as im aware ive never seen one before.


Under the pillion seat, i found this strange device... i am some how supposed to use it to lock my helmet to the bike??

i believe originally it was attached to the rear seat so you could hang it whilst accessing the compartment

Oh i also would really like to know if this is supposed to be like this...

This bit of black fairing is rather loose compared to the same bit on the opposite side. I was wondering if i was missing a fixing or is that normal for all NC30's?

again not many VFR's have these as they break or get lost, i dont have any and it doesnt bother me tbh.

Ok ok ok... 1 laaast thing....
Tonight i changed my tail/brake lights(lhs brake light not working) from the original jap spec 18/5W to UK spec 21/5W. Is this going to be a problem seeing as the bike is a Jap spec model?

no it wont be a problem at all, the current difference as follows Quote Ohms law I=PV
(18W / 14V = 0.9A) (21 / 14V = 1.5A)


Any help/advice is always appreciated!

Thanks everyone!

zYgoat wrote:
Under the pillion seat, i found this strange device... i am some how supposed to use it to lock my helmet to the bike??

Yes, I think it was intended that you undo the pillion seat, take out this loop and replace the pillion seat, then lock your helmet to the loop.

Oh i also would really like to know if this is supposed to be like this...

This bit of black fairing is rather loose compared to the same bit on the opposite side. I was wondering if i was missing a fixing or is that normal for all NC30's?

Very vague memories here... but it looks as though you're missing the 'v-piece' plastic that fits in front of the radiators. I don't have any, so only guessing.