Hi all,
might sound a bit obvious but i we have an after market fairing set on the bike (Hong Kong job) and have just got a seat lock of ebay and can't see how the bloody thing fits! any help would be appreciated
NC29 seat lock!
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Davez29
- Site Supporter
- Posts: 1268
- Joined: Sun Aug 03, 2008 8:38 pm
- Bike owned: NC29 forever
Re: NC29 seat lock!
Ok, until someone better comes along..
The lock fits into the hole with the outer ring in place, then a plate fits oround it from the inside, then a small clip slides across the centre in the lock side groves and hey presto lock is fitted. Hope that made sense..
dave
The lock fits into the hole with the outer ring in place, then a plate fits oround it from the inside, then a small clip slides across the centre in the lock side groves and hey presto lock is fitted. Hope that made sense..
dave
-
leopard_pagan
- Senior Member
- Posts: 1184
- Joined: Thu May 01, 2008 6:42 am
- Bike owned: CBR400/600 Fighter
- Location: Mildenhall-Suffolk
- Contact:
Re: NC29 seat lock!
hong-kong panels have no pre-cut holes i think.....?
-
Paul&Jax
- Settled in member
- Posts: 15
- Joined: Thu Oct 02, 2008 10:00 pm
Re: NC29 seat lock!
wish it was that straight forward! don't suppose anyones got a diagram?