I know that there are hundreds of jetting posts, but please help me.
What is a good starting point for jetting for a half system with a can for an rvf400? I was thinking 110 mains, extra .5 mm washer under the needles, and pilot screw at ? perhaps 1 3/8 turns out?
Everything else is standard on the bike
jetting for half system on rvf
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
trude
- Settled in member
- Posts: 15
- Joined: Tue Feb 24, 2009 3:43 am
- Location: New Zealand
-
Cammo
- Site Supporter
- Posts: 4505
- Joined: Thu May 01, 2008 12:35 am
- Bike owned: NC30
- Location: Melbourne, Australia
Re: jetting for half system on rvf
112 main jets will do, no need to raise the needles.
Pilot screw setting usually needs to be found by trial and error. Leave it at the stock setting and go from there I reckon.
Pilot screw setting usually needs to be found by trial and error. Leave it at the stock setting and go from there I reckon.
"It's just a ride" Bill Hicks