ok my sp1 runs without the quite gears very well and i removed them on the nc30 today though it seem the the nc quite cog takes more area on the driven gear than the sp1s. So is there anyone who had done this and had problems with it.
thanks mart,

I know a few people that run their bikes without the quietning gears, they sound a bit more like a bag of spanners at idle but no problems i've heard so far.

Neosophist wrote:I know a few people that run their bikes without the quietning gears, they sound a bit more like a bag of spanners at idle but no problems i've heard so far.

shame on you, its sounds as honda intended, luuuuvley all the racers do it....go for it

Drunkn Munky wrote:

Neosophist wrote:I know a few people that run their bikes without the quietning gears, they sound a bit more like a bag of spanners at idle but no problems i've heard so far.

shame on you, its sounds as honda intended, luuuuvley all the racers do it....go for it

Haha, if Mr H would have intended it to sound like that they wouldn't have put the quietners in there to begin with

I went to look at an MC22 (CBR250rr) and that had the gears took out of it, my first question was 'Whats wrong with the engine '

It's only really at idle you can here it anyway. Might get a pony or two also ^_^

I did it to my racebike and no worries yet... sounds evil

could anyone do a photo guide of how to do this? is it pritty simple?

I want to do it over winter along with ram air and a race loom.

Spike:

http://www.400greybike.info/newforum/vi ... a&start=10" onclick="window.open(this.href);return false;

My racebike has the quietening gears removed, lovely sound!

and if removed and shimmed properly it shouldn't sound any louder than standard spec, some i'm told !

my shims are all 0.15 in and 24 ex and it still sounds funny