NC30 'fork rings'

banoffee · Post by **banoffee** » Wed Oct 20, 2010 7:11 pm

Neosophist wrote:You mean the fork circlips?

They go on the fork-stantions, there should be a grove for them to go into, it stops the forks dropping out of the yokes.

When the circlip is against the yoke this is the factory height.

At least on the NC24 anyway.. should imagine it'd be the same on the 30. Not at home to check

For the circlip to be against the yoke on the NC30 that would put the fork in completely the wrong place surely?

CRM wrote:+1, stop the clipons dropping so in the grove in the forks

+1 for which option?

banoffee · Post by **banoffee** » Thu Oct 21, 2010 2:04 pm

Now sorted

Post by **Neosophist** » Thu Oct 21, 2010 4:31 pm

Ah awesome :)

Never did get around to checking.. think I was thinking of an XBR not even an NC24 now that I come to think about it... my memory is like fish latley

banoffee · Post by **banoffee** » Thu Oct 21, 2010 5:46 pm

yeah I thought that didn't sound right

Post by **Neosophist** » Fri Oct 22, 2010 11:03 am

Neosophist wrote:Ah awesome :)

Never did get around to checking.. think I was thinking of an XBR not even an NC24 now that I come to think about it... my memory is like fish latley

And come to think about it the circlips on the xbr go above the clipons and the clips go up to them.. god i need a holiday :D

NC30 'fork rings'

Re: NC30 'fork rings'

Re: NC30 'fork rings'

Re: NC30 'fork rings'

Re: NC30 'fork rings'

Re: NC30 'fork rings'