NC30 rear wheel cap 3D design

[GP1970]

Hello,

I just signed up as I purchased a NC30 here in Italy where I live. I was looking for a RC30 but, u know, the money for that are a bit to much... and in the meanwhile I've discovered the existance of the fantastic NC30 and bought one in a very original state already imported from Germany in 2020.

It is currently being prepared by the dealer (new tyres, liquids/oils changes, carburettor setup, etc...) and I'm working to find original spares to fit it at best changing parts in bad conditions or not original.

One of this part is the rear wheel white plastic cap which is unavailable from any spare parts site and I think it cannot be find anymore nowaday... (honda part 42603MR8000 - COVER,RR.WHEEL NU)

So, I've decided to design it by 3D modelling and print it using a similar plastic material but I've just some pictures and not a real part to copy!!!

Is anyone out there who owns an NC30 (with the original part) who can be so kind to take some measurement of the cap and some picture of the inner side?

My intent is to replicate the original one and share for free the 3D model in order for everyone to print/build one for himself (on thingiverse and similar)

Thanks to everybody!