De-restricted NC35, bike acting weird

Macaroni646 · Post by **Macaroni646** » Tue Nov 03, 2015 6:49 am

Hi guys,

I used this http://www.veaminicori.talktalk.net/Art ... iction.pdf guide to de-restrict my NC35 and now after I accelerate to a certain point in every gear, the bike starts to struggle. It's sort of like it's trying to half restrict the speed that I'm currently going, but not completely stopping me from going faster.

I bent that small tab but it wasn't completely 100% flat, more like 80-90% flat, does it have to be 100% flat? Or can I just clip off that small bent bit altogether?

Cheers

Post by **Drunkn Munky** » Tue Nov 03, 2015 9:06 am

Does it cut to 2 cylinders around 5-6k rpm

Post by **Neosophist** » Tue Nov 03, 2015 9:24 am

as above, did you re-connect all the wires for the speedo restictor circuit? if they are not connected properly the bike will cut the rpm at 5500

Macaroni646 · Post by **Macaroni646** » Tue Nov 03, 2015 10:31 am

That must be it. I will recheck tomorrow. Cheers guys

Macaroni646 · Post by **Macaroni646** » Thu Nov 05, 2015 2:27 am

Silly me put the little metal tab the wrong way. Was meant to go over the cogs, I put it under. All fixed now

De-restricted NC35, bike acting weird

De-restricted NC35, bike acting weird

Re: De-restricted NC35, bike acting weird

Re: De-restricted NC35, bike acting weird

Re: De-restricted NC35, bike acting weird

Re: De-restricted NC35, bike acting weird