Fuel pump relay nc23

[tr8theshape]

Hi all,

I think that I have a problem with the fuel pump relay on my nc23. It is getting 12v but giving out .15v which is not enough to run the pump. I have jumpered the 12v input and the pump output wires on the relay connector block and the pump runs fine.

I understand that a standard car relay can be used but am not sure how this should be wired up. From what I understand the relay should have a 12v input, 12v output, ground and a 'trigger'. The nc23 fuel pump relay seems to have two inputs from the coils and a 12v input and output.

Can a standard relay be used if I use the coil inputs as ground and triggers?

Or alternatively is there a way of getting one of these relays cheap from another bike or something??

Thanks in advance!

Dave.

[dunkenb]

A relay from a cbr600 should be exactly the same.

[dunkenb]

Or try this ........
http://www.fireblades.org/forums/honda- ... matic.html

[tr8theshape]

Cheers gents,

Bought the right bit in the end!

[tr8theshape]

Turns out it wasn't the relay but was a very naughty earth!