Various NC30 questions

[lukemillar]

Hey all,

I'm about 70% of the way through building a 2nd NC30 out of all the spares from my race bike but am stuck on a couple of things.

1- Routing of the loom around the headlights- If anyone has a pic, that would be great

2- Speedo mounting. It it held in place just by those 2 rubber plugs and bolts? Mine seems very wobbly

3- Pic of underneath the seat fairing - Mainly the latch system and helmet holder

4- EDIT - Just saw the thread below this one!

Lastly, I only have 1 lockset for 2 bikes, so I was going to use it on the road bike and convert the ignition to an on/off switch. However, with regards to the tank - Does anyone have any experience with these caps from China on ebay? I'm looking at something like this:

http://www.ebay.com/itm/CNC-Fuel-Gas-Ta ... 6d&vxp=mtr

Thanks for your help!
Luke

[CMSMJ1]

For a screw on cap? That link is fecked.

Ask Kayla on here - She had/has a sale on, or did do, for cheap caps.

http://www.projection-components.co.uk/ ... s-60-c.asp

[lukemillar]

For a screw on cap? That link is fecked.

Ask Kayla on here - She had/has a sale on, or did do, for cheap caps.

http://www.projection-components.co.uk/ ... s-60-c.asp

Crap - I think the link screwed up when I edited the post

Basically, yep - the caps is pretty much identical to those on Kayla's site. Thanks for the link!

[Haydn]

Be careful with the Chinese ones. Mine was supposed to be brushed finish but turned out to be cheap chrome plating with CBR on it. The o ring was not fuel resistant, swelled and fell in the tank on my first track day. Managed to fish the o ring out and now just run it without, it does the job for a track bike with no leaks but it's not pretty.