Perhaps someone with a bit more knowledge can help me out here? How different is the chassis between the 2 in terms of engine/swing arm mounting positions? I am looking for some measurements or clarification they are definitely different or the same, whichever so I can get a bike to checked out and then get my Spider Stand (similar to the Bursig workshop stand, but made in Aus and about $300) ordered...
Please help...
NC30 versus NC35 chassis
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Cammo
- Site Supporter
- Posts: 4505
- Joined: Thu May 01, 2008 12:35 am
- Bike owned: NC30
- Location: Melbourne, Australia
Re: NC30 versus NC35 chassis
The front engine mount between the 2 models is quite different:
- the rvf frame mounts both the front and rear heads to the frame
- the vfr frame mounts the rear head and front crankcase to the frame
I can't really help with the rest...
- the rvf frame mounts both the front and rear heads to the frame
- the vfr frame mounts the rear head and front crankcase to the frame
I can't really help with the rest...
"It's just a ride" Bill Hicks
-
al.ramsay
- Settled in member
- Posts: 14
- Joined: Sat Apr 27, 2013 9:30 am
Re: NC30 versus NC35 chassis
Thanks Cammo,
I think the rear bolt up points are very close (mm's different if at all) so these would at least be enough to get things started for my new stand.
I think the rear bolt up points are very close (mm's different if at all) so these would at least be enough to get things started for my new stand.