I've just replaced the choke cable before putting the carbs back on. What actually holds the outer part of the cable in the lever housing? There's nothing to stop it pulling out. The one I took off had a couple of cable ties holding it to the housing bracket. Am I missing a small clip?
Cheers
NC30 choke cable question
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
CMSMJ1
- Moderators
- Posts: 7152
- Joined: Thu May 01, 2008 9:42 am
- Bike owned: NC30-No9
- Location: Chesterfield, United Kingdom
Re: NC30 choke cable question
The lever on the carbs? It has a little bracket that screws on.
IMPERATOR REX ANGLORUM
The V4 is the law..
NC30 - No9 - my old mate
The V4 is the law..
NC30 - No9 - my old mate
-
Haydn
- Settled in member
- Posts: 95
- Joined: Sun May 06, 2012 10:03 am
Re: NC30 choke cable question
No, the lever you use to apply the choke. The carb end is clamped but there is nothing to keep the cable in the plastic housing the other end. It's no bother I will just use cable ties to hold it in place again put just wondered how it should be from the factory.