NC30 rear hub question

bollo · Post by **bollo** » Mon Jan 07, 2013 9:10 am

hi all just wat to know if the (look at the pic) threaded part that comes out from the hub for the wheel nut to screw onto & the locking pi goes through should be tight as in no movement or loose as in can wiggle ?

Post by **Drunkn Munky** » Mon Jan 07, 2013 9:24 am

A little bit of movement is fine as it will tighten when you torque the wheel nut up

bollo · Post by **bollo** » Mon Jan 07, 2013 11:42 am

i have no idea how long ago the bearings & seals where replaced so i am going to change them all , also doing the front to

Post by **CMSMJ1** » Mon Jan 07, 2013 11:45 am

That threaded section can pull out the other side - it does wobble a touch, not to worry !

Post by **Drunkn Munky** » Mon Jan 07, 2013 12:12 pm

And has nothing to do with the bearing. If your concerned about the bearing move the rear caliper out of the way and stick the wheel back on, you will then be able to feel any play or roughness in the bearings.

NC30 rear hub question

NC30 rear hub question

Re: NC30 rear hub question

Re: NC30 rear hub question

Re: NC30 rear hub question

Re: NC30 rear hub question