When I go from a standing still and try to take of fast and as soon as I let the clutch fully out it near enough dies then it picks up again and I'm going.
Is this normal for a standard setup + slip on can
Pete
Nc30 wont accelerate hard
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Causon67
- Settled in member
- Posts: 119
- Joined: Fri Jan 28, 2011 12:29 am
- Bike owned: NC30
- Location: Gloucestershire, UK
-
VFRkieran
- Site Supporter
- Posts: 839
- Joined: Fri May 06, 2011 8:37 pm
- Bike owned: NC30, NSR250, CBR600, TS125
- Location: Oxfordshire
Re: Nc30 wont accelerate hard
Does it just do it when hot, or all the time? Could be your releasing the clutch too early, mines similar have to slowly release the clutch to get the best out of it or the revs drop right down.
-
Cammo
- Site Supporter
- Posts: 4505
- Joined: Thu May 01, 2008 12:35 am
- Bike owned: NC30
- Location: Melbourne, Australia
Re: Nc30 wont accelerate hard
Symptoms like this can be caused by the pilot screws incorrectly adjusted.
"It's just a ride" Bill Hicks