NC30 - Ignitech help

[lukemillar]

Hey all,

Finally got my NC30 Ignitech hooked up to the bike. The problem is, I can't seem to get it to talk to the software. When I connect it, I get the New Hardware Wizard pop up, but I can't seem to find any drivers for the unit. If I just cancel that, then it says PC not connected when I launch the software, even if I cycle through all the COM ports.

Has anyone got any ideas? Do you need driver for the unit?

I'm running the software on Windows XP

Thanks
Luke

[Drunkn Munky]

Isnt there a USB driver you need to download from the website? I deem to remember doing this before i could get it to talk to my laptop.

[lukemillar]

Hmmm, that makes sense. Can't seem to connect to the ignitech website at the moment - Does anyone happen to have a copy of this driver handy that they could email me?

Cheers
Luke

[Drunkn Munky]

whats ya email?

[lukemillar]

Pm'd

[lukemillar]

Yep - that fixed it. Needed the USB-> serial driver. Thanks Tony - Karma your way!

[Drunkn Munky]

No problem, don't forget there's a fix that Rick o released a week or so ago for the maps, without the fix the units are down on power.

[lukemillar]

Yep - that is what I was sorting!