does the all the fairing on the rear end have to be removed to fit the lock mechanism!
i cant get the damn thing lined up but im hoping theres a nack to it and i dont need to dismantle the rear end aswell as the front
nc30 vfr seat lock mechanism
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
leerc
- Settled in member
- Posts: 129
- Joined: Wed Nov 09, 2011 12:15 pm
-
Neosophist
- Moderators
- Posts: 8172
- Joined: Fri Jul 04, 2008 1:01 pm
- Bike owned: CBR954
Re: nc30 vfr seat lock mechanism
The rear seat cowl comes off as a complete unit and is a doddle to take off.leerc wrote:does the all the fairing on the rear end have to be removed to fit the lock mechanism!
i cant get the damn thing lined up but im hoping theres a nack to it and i dont need to dismantle the rear end aswell as the front
Undo the 3 x cross head large screws on each side (6 total)
Remove the passanger seat.
The whole lot lifts up from the rear, might need a little wiggle, dont' lift it too far as you'll need to disconnect the tail light plug before it'll pull free.
The rider seat and tail light stay attached to it. You can split it further after it's off but you dont' need to do that. So it's only 6 bolts and unplug one connector, will make doing the job easier
xivlia wrote:i dont go fast on this bike so really do not need a rear brake.. /
vic-vtrvfr wrote:Ask xivlia for help, he's tackled just about every problem u could think of...