nc35 torque settings
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
swdesigns
- Settled in member
- Posts: 50
- Joined: Thu Dec 31, 2009 11:03 pm
nc35 torque settings
hi i am replacing my headrace bearings and need the torque settings for the steering stem lock nut and the head stock bolt ? thanks
-
arsey30
- Senior Member
- Posts: 1218
- Joined: Tue Apr 29, 2008 9:13 pm
- Bike owned: ftr223 650 bros
- Location: Surrey
Re: nc35 torque settings
NC30
The lock nut should be finger/hand tight with a new lock tab, but backed off a 1/4 turn with an old one, but the adjuster nut 36ft/lbs.
Top nut 101 ft/lbs,
top yoke 8
bottom yoke 28
clip on 9
NC35
As above but top nut 105nm
Adjuster nut 25nm
Top yoke 23nm
bottom yoke 40nm
Clip on 27nm
Dave.
The lock nut should be finger/hand tight with a new lock tab, but backed off a 1/4 turn with an old one, but the adjuster nut 36ft/lbs.
Top nut 101 ft/lbs,
top yoke 8
bottom yoke 28
clip on 9
NC35
As above but top nut 105nm
Adjuster nut 25nm
Top yoke 23nm
bottom yoke 40nm
Clip on 27nm
Dave.
-
Speedy
- NWAA Supporter
- Posts: 483
- Joined: Fri May 02, 2008 8:29 pm
- Bike owned: RVF400RR, ER6n
- Location: Middx, U.K.
Re: nc35 torque settings
swdesigns, you got a PM!
When the mind is relaxed, the body will go faster! 