Hey you guys
I'm after some help with the pilot screws on an nc30 carbs
behinde the screw you have a spring, a washer and a o ring (seal). Is it possible to purchase just the o ring on it's own, if so does anyone know where from or got a part number
cheers phil
Pilot screw help
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
fatkid_loves_cake
- Settled in member
- Posts: 45
- Joined: Thu Jul 10, 2008 9:06 pm
- Bike owned: Tzr125. Nc30
- Location: Hull
-
Cammo
- Site Supporter
- Posts: 4505
- Joined: Thu May 01, 2008 12:35 am
- Bike owned: NC30
- Location: Melbourne, Australia
Re: Pilot screw help
I believe they're part of the honda float bowl gasket kit (pricey!), you can't buy them separately.
Any suitable sized viton (fuel resistant!) o-rings will be fine to use.
Any suitable sized viton (fuel resistant!) o-rings will be fine to use.
"It's just a ride" Bill Hicks
-
The Novice
- Site Supporter
- Posts: 422
- Joined: Thu Jul 15, 2010 12:59 pm
- Bike owned: NC23 NC30 CRM250
- Location: West Midlands
Re: Pilot screw help
I got some from a massive pack of various sized orings in halfords. They fit a treat on my triarm. The whole pack is expensive, so I found an open pack 
. If they have them there though you will get them in any decent motor factor
. If they have them there though you will get them in any decent motor factor