Koso gauges on NC30

bxtra · Post by **bxtra** » Tue Apr 12, 2011 10:58 pm

Hi guys,

Anyone here used any of the Koso multifunction gauges with an NC30? Any problems wiring up or anything to note about them? Looking to fit a set to my NC30 project ('93 grey/N), like the look of them and the functionality. I haven't looked to see if the bike has been derestricted or not yet but not sure if that might have an effect post-gauge change also...?

Post by **STYLER** » Tue Apr 12, 2011 11:30 pm

I want to put a Koso dash or similar on me bike too!

Ive seen a Koso dash on Drunkn Munky and Martins bikes maybe try asking them?

Post by **Drunkn Munky** » Tue Apr 12, 2011 11:43 pm

There easy enough to setup, they can also use the standard speedo pickup so no need for extra speed sensors on the front wheel, just use this formula when entering the value for the wheel circumference,

Rear wheel circumference divided by the number of turns of the speedo cable does on 1 full turn of the rear wheel.

Example, if rear wheel circumference = 2000mm and the speedo cable turns 3.75 times to 1 full rotation of the rear wheel then it's 2000 divided by 3.75 = 533

bxtra · Post by **bxtra** » Wed Apr 13, 2011 3:27 pm

Awesome, ta munky

Post by **VFR400+** » Wed Apr 13, 2011 4:39 pm

Looks great

Post by **geebus** » Wed Apr 13, 2011 10:10 pm

oh i want one of these...expensive though

Koso gauges on NC30

Koso gauges on NC30

Re: Koso gauges on NC30

Re: Koso gauges on NC30

Re: Koso gauges on NC30

Re: Koso gauges on NC30

Re: Koso gauges on NC30