afternoon chaps, recently my NC30 has been having a slight issue... shes fine with half throttle of less, but when i pin it open she'll run fine up untill about 9k revs then it feels as if the clutch is being pulled in slowly... revs rise but no pull....
is my clutch on the way out? or should i be looking towards the carbs?
tis quite a head scratcher as its only started happening recently.
thanks in advance....
NC30 loosing power on full throttle
Forum rules
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
Please can you post items for sale or wanted in the correct For Sale section. Items / bikes for sale here will be removed without warning. Reasons for this are in the FAQ. Thanks
-
Smoky
- Familiar Member
- Posts: 263
- Joined: Wed Sep 24, 2008 9:43 am
- Bike owned: NC30
- Location: Hackney. East London
-
Neosophist
- Moderators
- Posts: 8172
- Joined: Fri Jul 04, 2008 1:01 pm
- Bike owned: CBR954
Re: NC30 loosing power on full throttle
If your revs are going up and your bike isn't increasing in speed the clutch is slipping.
This could either be due to worn plates and / or weak springs.
My 24 was slipping terrible around 9 / 10k rpm.
Plates were fine but the springs had gone weak.
This could either be due to worn plates and / or weak springs.
My 24 was slipping terrible around 9 / 10k rpm.
Plates were fine but the springs had gone weak.
xivlia wrote:i dont go fast on this bike so really do not need a rear brake.. /
vic-vtrvfr wrote:Ask xivlia for help, he's tackled just about every problem u could think of...
-
Smoky
- Familiar Member
- Posts: 263
- Joined: Wed Sep 24, 2008 9:43 am
- Bike owned: NC30
- Location: Hackney. East London
Re: NC30 loosing power on full throttle
phew- was hoping itd point towards the clutch. (no good at carbs)
to be fair, the clutch thats in there now has been in situ for god knows how long. shall treat her to a new set of plates and springs.
cheers fella!
to be fair, the clutch thats in there now has been in situ for god knows how long. shall treat her to a new set of plates and springs.
cheers fella!