NC21 engine mounts

[KiwiNC21]

I have just acquired and am installing a "new" powerplant in my NC21. The problem I have is that it has been some months since the extraction of the old motor and although I had all bolts etc all separated(ish) I don't remember where all the spacers go, it seems as though I may have some spare!!!?

If anyone has an NC21 they could look over for me and describe the spacer placement would be a great help. There are 3 different spacer sizes, but not sure if everymount requires one, it doesn't seem that self explanatory even with the engine "in situ", and the microfiches etc are not exactly clear.

[KiwiNC21]

Or an NC24, presumably engine mounts etc are the same

[Old Painless]

Have you forgotten the ones which go behind the engine on the rear mounts ?

It goes without saying you shouldn't have any spare.

Is the NC21 the same mounts as the NC24 ? Mine in the garage is currently without panels and i wouldn't mind taking photos ?

[Neosophist]

Yeah there the same frame and the moutings are the same..

You shouldn't have any left over.

2 at the back and 2 at the sides.. 2 at the sides top, the lowest front ones don't have any spaces.

I can get you specific details if you can't fathm it out :)

[KiwiNC21]

I know I shouldn't have spares but I know that there are a couple of spares floating around which the kids have been kicking around, great!! When I got this other motor the previous owner had made som "legs" to stand it up and these had some spacers on it, that's where the extras came from, problem is, I have odd numbers/sizes.

There are 3 differents size spacers, just need some prompting as to where the larger diameter ones and the deeper/thicker 8mm ones are supposed to go.

I have 2 thick spacers at the rear with the 8mm bolts and 2 large ones at the top mounts with the 10mm bolts.
But it seems there is only room for a spacer on the r/h side at the front mounts, no spacers at bottom/front mounts.

Cheers

[Neosophist]

the lowest front ones don't have any spaces.