30 engine into 35

Post by **mo haggs** » Sat Feb 19, 2011 11:00 pm

talk to me - whats required to fit an nc30 engine into an nc35

and what are the benifits

Post by **Drunkn Munky** » Sat Feb 19, 2011 11:05 pm

Im just doing this myself mate, no benifits for me for taking out a 70+ 35 motor for a standard 30 lump except its going to get me to spain and back. Im told its straight forward so im hoping it'll seem obvious when i get it in the frame.

Personally i like the tall 1st gear on the 30.

Post by **Cammo** » Sat Feb 19, 2011 11:35 pm

Drunkn Munky wrote:Personally i like the tall 1st gear on the 30.

You'll need the 30 loom, cdi and tacho unless you change the pickups for rvf so you can use the rvf electrics.

Post by **Drunkn Munky** » Sat Feb 19, 2011 11:39 pm

Im just changing the pick ups, makes much more sense than changing the loom

Post by **royster81** » Sun Feb 20, 2011 9:28 am

Go for it mo

Post by **royster81** » Sun Feb 20, 2011 7:19 pm

What would be easier?

Vfr motor,vfr loom, vfr clocks and csi or

Vfr motor and rvf pick ups and whatever else is needed?

I thought it would be easier to treat it as a vfr ( or keep all the electrics vfr ) but in a different frame

Post by **Drunkn Munky** » Sun Feb 20, 2011 7:28 pm

In my case its easier to change the pick ups as i have a ignitech cdi, koso dash, cbr coils. This way swapping between the 2 engines is a doddle

Post by **mo haggs** » Mon Feb 21, 2011 11:18 am

vfr engine, rvf pick-ups and rvf starter clutch (pulse generator)

have been purchased so i will be running rvf loom ect

Post by **mo haggs** » Mon Feb 21, 2011 11:19 am

i think a buid thread is getting close

Post by **Drunkn Munky** » Mon Feb 21, 2011 11:54 am

For those that have the 30 motor in a 35 are any of the spacers different?

30 engine into 35

30 engine into 35

Re: 30 engine into 35

Re: 30 engine into 35

Re: 30 engine into 35

Re: 30 engine into 35

Re: 30 engine into 35

Re: 30 engine into 35

Re: 30 engine into 35

Re: 30 engine into 35

Re: 30 engine into 35